The Four Stages of Curing

“Is it dry yet”? Or “How much longer?” Are common questions asked during a curing process. The proper mechanism for finish drying and curing varies by type of finish. It is important to know that each type of finish has their own needs and drying points, but there are several commonly used terms to describe certain points along the dry curve regardless of the type finish. These are the four most common stages of curing.

Set Point:  The first stage that a finish arrives at is the point where it will no longer flow and level. This is called the set point. It is not dry, it may be tacky, it may even feel liquid when touched, but enough liquid carrier has evaporated so the product will not flow and level any further. This is sometimes referred to as the gel point in two part systems.

Dry to Touch: This is the second stage of finish drying. It is just what it says, if you lightly touch the surface, liquid will not transfer to your finger. It will be dust free at this point in the dry cycle, no dust sticks to the surface. Most times it will be wet underneath, only the “skinned” over surface is dry. This is also the point at which air movement can be started buy cialis online across the surface to draw off the liquid carrier.

Dry Hard: Third Stage is hard enough and dry enough to go on to the next steps. The floor can be screened and another coat added, or can be walked on lightly. Normally it cannot be covered or rugs put back at this dry stage even though many contractors turn the job over to the owner at this point.

Fully Cured: This will vary from days to months depending on the type of finish and the conditions of the jobsite. It is the point that the finish develops 100% of all its properties.

These drying stages are well known by the finish manufacturers and any contractor can get a good estimate of the time the various stages will take to develop by talking with their supplier. When asking the supplier, the contractor would help himself by accurately describing the conditions to the best of his knowledge.

Micah PetersenMicah Petersen, Product Manager for Basic Coatings, spent the first 15 years of his career as a Research and Development Chemist before becoming Product Manager. In his free time he enjoys spending time with his family and a multitude of outdoor activities. For further questions regarding hardwood floor care and Basic Coatings, please email Micah at Micahblog@basiccoatings.com.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>